How Western Belt Sizing Works? Western belts are sized differently from pants sizes. Instead of matching your jeans size exactly, you measure where the belt actually fastens. Most western belt sizes are based on the measurement from the buckle end where the belt attaches to the hole you use. So a western belt size is usually a few inches larger than your waist or hip measurement. The Easiest Way to Measure Stand in front of a mirror with a belt you already wear comfortably. Put it on in the notch you use most. Measure from the buckle end (where the belt attaches) to that notch. That number in inches is your belt size. If you do not have a belt to measure, use a soft tape measure. Wrap it around your waist where your pants normally sit. Make sure it is snug but not tight. That measurement is a good starting point, but for a western belt add about 1 to 2 inches to it for comfort and proper fit. For example, if your waist measures 34 inches, a western belt in size 36 will usually sit best. Why You Add Inches Western belts often have larger buckles and thicker leather. If you sized it exactly to your waist measurement, the belt could feel tighter than expected. Adding an inch or two gives room for comfort and ensures the belt sits in the place you want. Checking the Fit When the belt is on, the buckle should sit comfortably at the front without pulling. Most of the belt end should point to your left when fastened. If the belt is too long and hangs down, you might consider a smaller size or adjusting the notch placement. The belt should fit comfortably on the middle hole. That gives room to tighten or loosen slightly if you need. Learn more: https://jacksonswestern.com/accessories/belts/